Toyota Harrier ASU60/ASU65 Knock Sensor Wiring Diagram

[Roland.O]

This diagram give you complete circuit tracks, wire colour codes and connector pinouts for the f1 plug assembly. It gives the procedures required to verify circuit continuity, test shield ground paths and isolate electrical signal interference from mechanical engine knock. Working without this OEM diagram increases the risk misdiagnosing functinal sensors.

Common questions that this diagram answers​

1. What is the connector pinout chart for the Toyota Harrier ASU60/ASU65 knock control sensor f1?
2. How do I test the signal wire and shield ground loop on an ASU60/ASU65 knock sensor harness?
3. What are the factory wire colours for the knock control sensor on a Toyota Harrier 8AR-FTS engine?

How to access the diagram​

Click on the link below to access the complete OEM Manual, within it you will find the Knock Sensor Wiring Diagram. I have given the screenshot below to help you quickly navigate to the section where the diagram is located. Once you find it, you can then print or save it. Let me know if you face any challenges or have any questions and I will be happy to answer in the thread below. Please note that the year in the document is not the YOM but the document release date so it covers the entire model range. Also note the document applies to all countries where the model is sold Including Singapore, Australia, Malaysia, Kenya, UK, New Zealand, etc.